 |
|
|
| |
|
|
|
|
|
|
- (2)
- (1)
- (1)
- (1)
- (3)
- (2)
- (1)
- (1)
- (7)
- (1)
|
|
| |
|
|
Build Your Online Product Catalogs?
| Product Name: |
Full Automatic Brick Setting Machine
|
| Supply Ability: |
50set/month |
| Related proudcts |
brick setting plant, setting machine, |
| Specifications |
various |
| Price Term: |
By T/T FOB |
| Port of loading: |
xinzheng,tianjin,shanghai or other main port |
| Minimum Order |
1 |
| Unit Price: |
negotiation |
|
Introduction of fully automatic hydraulic setting machine
Alias of setting machine: brick machine (robot), automatic setting machine, hydraulic setting machine. The machine adopts advanced PLC centralized control. Walking rotating adopts frequency conversion control, elevator, adopts hydraulic control, with high efficiency and energy saving, simple maintenance, low cost, reliable running etc. Automatic setting system represents the international most advanced level at present.
The composition of the setting system
Automatic setting machine mainly has special strip cutting machine, cutting machine, point blank machine, clip machine, cutter, walking system, lift system, rotation system, hydraulic system and electrical system, etc.
The working process of the automatic hydraulic setting machine
When the cutter cut a***e push the points on the billet board, point blank system, driving point blank plates open to points of action, a***e bricks article points, after the completion of the lift cylinder��?
when chuck to book clip blank ***ce, chuck clamp work, pick up the bricks, and then by the lifting cylinder chuck to scheduled heights, point blank systems and open between a***e air duct, walking device driver setting machine walking to the kiln car, rotating system action is completed, the kiln car to 90 °, and then lifting cylinder billet height down to reserve, chuck clamp open the a***e pieces in kiln car. Setting machine to complete the process of an automatic unburned brick pattern, through the above action cycle, it can complete the whole setting of kiln car, setting machine both of these functions through the electric centralized control, the operator corresponding to run the program, simply start can be run automatically. |
| Company: |
Zhengzhou mengda machinery factory
|
| Contact: |
Ms. mengda fanny |
| Address: |
No.11 Youyi street |
| Postcode: |
451200 |
| Tel: |
0371-69596251 |
| Fax: |
0371-69599779 |
| E-mail: |
|
|
|
Home
